Yeedercar Factory-Made Carbon Fiber Front Lip Splitter for BMW 1 Series F20 F21 M135i M Sport Base Hatchback (2011-2014)

A front splitter for the BMW 1 Series F20 F21 M135i M Sport Base Hatchback (2011-2014) that turns the standard front bumper into something closer to the factory aero pack, without swapping the whole bumper.

Layered from 3K 2×2 twill and cured under vacuum in our own autoclave, so the resin-to-fiber ratio stays consistent from part to part.

Fits: BMW 1 Series F20 F21 M135i M Sport Base Hatchback (2011-2014)

The mounting tabs follow the factory bumper contour of the BMW 1 Series F20 F21, so it lines up with the original fixing points.

Fitting is a two-person job: offer it up with tape in place, check the gaps left and right, then drive the self-tapping screws home through the pre-marked positions.

Sport and standard bumpers on the same model can sit at different heights – compare the photos with your own bumper before ordering.

Weave, finish and edge treatment are all chosen when you order: glossy 3K twill is the default, while matte, forged carbon, coloured clear coat and carbon-kevlar hybrids are produced on request.

• 3K twill, 6K twill, plain weave or carbon-kevlar hybrid
• Coloured tinted clear coat (red, blue, yellow)
• Logo application or badge cut-outs on request
• Gloss, matte, satin or forged carbon finish

A ceramic or wax coat once a season is all this needs – the clear coat handles UV, but it is not a scratch-proof layer.

Because the tooling is in-house, changes that a trader would refuse – a different weave, a logo under the clear coat, a slight trim to clear a roll cage – are normal work for us.

Every unit is checked against a photo checklist – pinholes, weave alignment, mounting-hole position and clear-coat flow – before it is packed.

One piece is fine for a first sample – there is no minimum order. When you need volume, the same mould runs batches of 50, 200 or 1,000+ pieces.

Made to order in our workshop, typically 10-15 business days before it ships worldwide with tracking, backed by a 12-month warranty against manufacturing defects.

In the box: lip, pre-applied 3M VHB tape, stainless self-tapping screws and a fitment card.