Carbon Fiber Trunk Spoiler for BMW F87 M2 2014 2018

On the BMW F87 M2 2014 2018 it removes the flat, unfinished look of the standard boot lid without going to a full wing.

Layered from 3K 2×2 twill and cured under vacuum in our own autoclave, so the resin-to-fiber ratio stays consistent from part to part.

Warm the boot lid, clean it with IPA, dry-fit with tape, then press and hold – about 30-40 minutes start to finish.

Fits: BMW F87 M2 2014 2018

The underside is moulded to the boot curvature of the BMW F87 M2 2014 2018, so the tape line contacts the panel evenly.

Aftermarket paint protection film or a previous spoiler leaves a residue line – clean it fully or the new tape lifts at the ends.

Weave, finish and edge treatment are all chosen when you order: glossy 3K twill is the default, while matte, forged carbon, coloured clear coat and carbon-kevlar hybrids are produced on request.

• Logo application or badge cut-outs on request
• Gloss, matte, satin or forged carbon finish
• 3K twill, 6K twill, plain weave or carbon-kevlar hybrid
• Coloured tinted clear coat (red, blue, yellow)

A ceramic or wax coat once a season is all this needs – the clear coat handles UV, but it is not a scratch-proof layer.

Quality control is a visual inspection plus a fit check on the master jig; anything with a lifted clear coat or a distorted mounting edge is rejected rather than shipped and discounted.

Because the tooling is in-house, changes that a trader would refuse – a different weave, a logo under the clear coat, a slight trim to clear a roll cage – are normal work for us.

One piece is fine for a first sample – there is no minimum order. When you need volume, the same mould runs batches of 50, 200 or 1,000+ pieces.

Allow 10-15 business days for production plus transit time; express DHL, UPS and FedEx options are available at checkout, and the part carries a 12-month warranty against manufacturing defects.

In the box: spoiler, pre-applied automotive tape, an alcohol wipe and a fitment card.